LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .
  2. Disconnect the input speed sensor electrical connector.
    3. Fig 1: View Of Input Speed Sensor
    GM48196Courtesy of GENERAL MOTORS CORP.
  3. Remove the input speed sensor retaining clip (441).
  4. Remove the input speed sensor (440).
    5. Fig 2: View of Input Speed Sensor and Damaged Speed Sensor Clip
    GM49299Courtesy of GENERAL MOTORS CORP.
  5. Inspect the input speed sensor (440) for the following conditions:
    • Damaged or missing magnet
    • Damaged housing
    • Bent or missing electrical terminals
    • Damaged speed sensor clip (441)
scientia non olet · About LEMON Manuals