LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Input Speed Sensor
    GM48196Courtesy of GENERAL MOTORS CORP.
  1. Install the input speed sensor (440).
  2. Install the input speed sensor retaining clip (441).
  3. Connect the input speed sensor electrical connector.
  4. Install the case side cover. Refer to Control Valve Body Cover Replacement .
scientia non olet · About LEMON Manuals