LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Right Front Wheel Drive Shaft Oil Seal
    GM784370Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the right stabilizer shaft link from the right lower control arm. Refer to Stabilizer Shaft Link Replacement .
  4. Remove the right tie rod end from the right steering knuckle. Refer to Steering Knuckle Replacement .
  5. Remove the right lower ball joint from the right steering knuckle. Refer to Steering Knuckle Replacement .
  6. Remove the right drive axle from the transaxle. Refer to Wheel Drive Shaft Replacement .
  7. Secure the right drive axle to the right steering knuckle and the strut.
  8. Use the J 6125-B  (3) and the J 23129  (4) to remove the oil seal (1) from the extension housing (2).
scientia non olet · About LEMON Manuals