LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the seal lip with transaxle fluid.
    2. Fig 1: Identifying Right Front Oil Seal With J 29130
    GM190628Courtesy of GENERAL MOTORS CORP.
  2. Install J 37292-B  in the seal (4). See Special Tools .
  3. Use J 29130  to install the new seal (4). See Special Tools .
  4. Remove the J 37292-B  . See Special Tools .
    5. NOTE: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface.
  5. Install the drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
  6. Install the right lower ball joint to the right steering knuckle. Refer to Steering Knuckle Replacement .
  7. Install the right tie rod end to the right steering knuckle. Refer to Steering Knuckle Replacement .
  8. Install the right stabilizer shaft link to the right steering knuckle. Refer to Stabilizer Shaft Link Replacement .
  9. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
    11. CAUTION: Refer to Transmission Overfill Caution .
  11. Check and fill the transaxle fluid as necessary.
  12. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals