Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the spring.
- Install the piston assembly.
- Install the O-ring.
- Install the servo cover.
- Install the servo cover bolts.
Tighten: Tighten the bolts to 12 N.m (106 lb in).
- Remove the drain pan from under the forward servo cover.
- Adjust the jackstand in order to raise the rear of the frame.
- Install the frame bolts. Refer to Frame Replacement .
- Remove the support from the rear of the frame.
- Install the power steering lines to the right side of the frame.
- Install the engine mount lower nuts. Refer to the following:
- Engine Mount Replacement for the 3.5L engine
- Engine Mount Replacement for the 3.9L engine
- Install the transaxle mount lower nuts. Refer to Transmission Mount Replacement - Left Side .
- Install the power steering gear. Refer to Steering Gear Replacement .
- Lower the vehicle.
- Remove the engine support fixture.
- Reset the TAP values. Refer to Transmission Adaptive Functions .
- Check and fill the transaxle as necessary.
CAUTION:
Refer to Fastener Caution
.
NOTE:
It is recommended that the transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
CAUTION:
Check the transmission fluid level immediately after adding fluid and before vehicle operation. Do not overfill the transmission. An overfilled transmission may result in foaming or fluid to be expelled out the vent tube when the vehicle is operated. Overfilling will result in possible damage to the transmission.