LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Fluid Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .
    2. Fig 1: Wiring Harness & Fluid Temperature Sensor
    GM48209Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the wiring harness assembly from the fluid temperature sensor (391).
  3. Remove the fluid temperature sensor (391).
scientia non olet · About LEMON Manuals