LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Final Drive Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exploded View Of Carrier/Sun Gear Thrust Bearing & Internal Gear/Parking Gear Thrust Bearing
    GM214412Courtesy of GENERAL MOTORS CORP.
  1. Assemble the sun gear thrust bearing (698), the differential carrier sun gear (697), the park gear (696), the internal gear thrust bearing (695) and the sun gear shaft (689) into the differential carrier (700).
    2. Fig 2: Identifying Differential Carrier
    GM214413Courtesy of GENERAL MOTORS CORP.
  2. Install the differential carrier into the case.
    3. Fig 3: Drive Axle Retainer Rings & Output Shaft
    GM214419Courtesy of GENERAL MOTORS CORP.
  3. Install the drive axle retainer rings (509) to the output shaft (510).
  4. Hold the front differential carrier in place and carefully install the output shaft to the transmission through the left wheel opening.
  5. Install the case extension housing. Refer Case Extension Replacement .
  6. Install left drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
scientia non olet · About LEMON Manuals