LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Valve Lifter Guides
    GM1557686Courtesy of GENERAL MOTORS CORP.
  1. Coat the valve lifters using prelube. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  2. Install the valve lifters to the cylinder bores.
  3. Apply threadlock to the valve lifter guide bolt threads. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  4. Install the valve lifter guides.
    5. CAUTION: Refer to Fastener Caution .
  5. Tighten the valve lifter guide bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Install the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
  7. Install the lower intake manifold. Refer to Lower Intake Manifold Replacement .
scientia non olet · About LEMON Manuals