LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Oil Level Indicator & Tube
    GM1581866Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the oil level indicator tube O-ring seal with clean engine oil.
  2. Install the oil level indicator tube into the engine block.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil level indicator tube bracket bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  4. Install the oil level indicator.
scientia non olet · About LEMON Manuals