LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Pressure Sensor Heat Shield & Nut
    GM1609656Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil pressure sensor heat shield nut and shield.
    2. Fig 2: Identifying Electrical Connector
    GM1608498Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the engine oil pressure sensor electrical connector (1).
    3. Fig 3: Engine Oil Pressure Sensor
    GM1609660Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine oil pressure sensor.
scientia non olet · About LEMON Manuals