LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Mount Strut Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount Struts
    GM1607932Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut(s).
  2. Install the engine mount strut to engine mount strut bracket bolts/nuts.
    3. Fig 2: View Of EVAP Canister Purge Solenoid Electrical Connector
    GM1608290Courtesy of GENERAL MOTORS CORP.
  3. On the right side, ensure that the engine harness clamp is sandwiched between the bolt (4) and the strut bracket.
    4. CAUTION: Refer to Fastener Caution .
  4. Tighten the engine mount strut to engine mount strut bracket bolts/nuts.

    Tighten:  Tighten the bolts/nuts to 50 N.m (37 lb ft).

    5. Fig 3: View Of Engine Mount Strut & Radiator Support Bolts
    GM1607935Courtesy of GENERAL MOTORS CORP.
  5. Install the engine mount strut to radiator support bolts.

    Tighten:  Tighten the M10 bolts to 58 N.m (43 lb ft) and Tighten the M8 bolts to 26 N.m (19 lb ft).

scientia non olet · About LEMON Manuals