LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Mount Strut Bracket Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Coolant Inlet And Outlet Hoses/Pipes
    GM1608325Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (LZE, LGD Static Fill) or Cooling System Draining and Filling (LZE, LGD GE47716 Fill) .
  2. Remove the engine mount strut. Refer to Engine Mount Strut Replacement .
  3. Remove the heater inlet and outlet hose clamp nuts from the throttle body studs.
  4. Reposition the heater inlet and outlet hose clamps at the pipes.
  5. Remove the heater inlet and outlet hoses from the engine pipes.
  6. Remove the heater inlet and outlet hose clamp from the throttle body studs.
  7. Reposition the inlet and outlet hoses.
    8. Fig 2: View Of Engine Mount Strut Bracket & Cylinder Head
    GM1607941Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine mount strut bracket to cylinder head bolts.
  9. Remove the engine mount strut bracket.
scientia non olet · About LEMON Manuals