LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Mount Strut Bracket Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount Strut Bracket & Cylinder Head
    GM1607941Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the engine mount strut bracket to the cylinder head.
  2. Install the engine mount strut bracket to cylinder head bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: Coolant Inlet And Outlet Hoses/Pipes
    GM1608325Courtesy of GENERAL MOTORS CORP.
  3. Position and install the heater inlet and outlet hoses to the engine pipes.
  4. Install the heater inlet and outlet hose clamp to the throttle body studs.
  5. Position the heater inlet and outlet hose clamps at the pipes.
  6. Install the heater inlet and outlet hose clamp nuts to the throttle body studs.

    Tighten:  Tighten the nuts to 10 N.m (89 lb ft).

  7. Install the engine mount strut. Refer to Engine Mount Strut Replacement .
  8. Fill the cooling system. Refer to Cooling System Draining and Filling (LZE, LGD Static Fill) or Cooling System Draining and Filling (LZE, LGD GE47716 Fill) .
scientia non olet · About LEMON Manuals