LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Mount Strut Bracket Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Harness Clip (2) & Strut Bracket
    GM1608276Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine mount strut. Refer to Engine Mount Strut Replacement .
  2. Remove the engine harness clip (2) from the strut bracket.
    3. Fig 2: View Of Air Conditioning (A/C) Compressor Front Bolt/Nut
    GM1608216Courtesy of GENERAL MOTORS CORP.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the air conditioning (A/C) compressor front bolt/nut.
    5. Fig 3: A/C Compressor Rear Bolt
    GM1608220Courtesy of GENERAL MOTORS CORP.
  5. Remove the A/C compressor rear bolt.
  6. Reposition the A/C compressor.
    7. Fig 4: Locating Engine Mount Strut Bracket & Lower Engine Bolts
    GM1607937Courtesy of GENERAL MOTORS CORP.
  7. Remove the engine mount strut bracket to engine lower bolts.
  8. Lower the vehicle.
  9. Remove the engine mount strut bracket to engine upper bolt.
  10. Remove the engine mount strut bracket.
scientia non olet · About LEMON Manuals