LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount Lower Nuts
    GM1607922Courtesy of GENERAL MOTORS CORP.
  1. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  2. Remove the engine splash shield. Refer to Engine Splash Shield Replacement (Right) or Engine Splash Shield Replacement (Left) .
  3. Remove the engine mount to frame nuts.
    4. Fig 2: Locating Engine Mount Bracket Bolts
    GM1607926Courtesy of GENERAL MOTORS CORP.
  4. Place an adjustable jack and a block of wood under the oil pan.
  5. Remove the engine mount bracket bolts.
  6. Using the adjustable jack and block of wood, raise the engine until the engine mount/bracket can be removed.
  7. Remove the engine mount/bracket from the vehicle.
scientia non olet · About LEMON Manuals