LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount & Bolts
    GM1607930Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the engine mount bracket to the mount.
  2. Install the engine mount bracket to mount nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  3. Install the engine mount. Refer to Engine Mount Replacement .
scientia non olet · About LEMON Manuals