LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Front Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Front Cover, Bolts & Gasket
    GM1557694Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (LZE, LGD Static Fill) or Cooling System Draining and Filling (LZE, LGD GE47716 Fill) .
  2. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  3. Remove the oil pan. Refer to Oil Pan Replacement .
  4. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  5. Remove the crankshaft position actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
  6. Remove the thermostat housing. Refer to Engine Coolant Thermostat Housing Replacement (LGD/LZE) .
  7. Remove the water pump. Refer to Water Pump Replacement (LGD/LZE) .
  8. Remove the engine front cover bolts.
  9. Remove the engine front cover.
  10. Remove the engine front cover gasket.
scientia non olet · About LEMON Manuals