LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Front Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Front Cover, Bolts & Gasket
    GM1557694Courtesy of GENERAL MOTORS CORP.
  1. Install the engine front cover gasket.
  2. Install the engine front cover.
    CAUTION: Refer to Fastener Caution .
  3. Install the engine front cover bolts.

    Tighten:  Tighten the bolts to 257 N.m (18 lb ft).

  4. Install the water pump. Refer to Water Pump Replacement (LGD/LZE) .
  5. Install the thermostat housing. Refer to Engine Coolant Thermostat Housing Replacement (LGD/LZE) .
  6. Install the crankshaft position actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
  7. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  8. Install the oil pan. Refer to Oil Pan Replacement .
  9. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  10. Fill the cooling system. Refer to Cooling System Draining and Filling (LZE, LGD Static Fill) or Cooling System Draining and Filling (LZE, LGD GE47716 Fill) .
scientia non olet · About LEMON Manuals