LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Flywheel
    GM1526753Courtesy of GENERAL MOTORS CORP.
  1. Position the flywheel to the crankshaft.
  2. Install the flywheel bolts finger tight.
  3. Use the J 37096  to secure the flywheel in order to prevent the crankshaft from rotating. See Special Tools .
    CAUTION: Refer to Fastener Caution .
  4. Tighten the engine flywheel bolts.

    Tighten:  Tighten the bolts to 70 N.m (52 lb ft).

  5. Install the automatic transaxle, if equipped. Refer to Transmission Replacement (LZE and LZ9) .
scientia non olet · About LEMON Manuals