LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt
    GM1607918Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Rotate the drive belt tensioner clockwise in order to release the spring tension.
  3. Remove the drive belt from around the tensioner pulley.
  4. Remove the drive belt from around all the other pulleys.
  5. Remove the drive belt from the vehicle.
scientia non olet · About LEMON Manuals