LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Camshaft Position Actuator Magnet Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Camshaft Position Actuator Magnet Electrical Connector
    GM1611455Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the camshaft position actuator magnet electrical connector (2).
    3. Fig 2: Identifying Camshaft Position Actuator Magnet & Bolts
    GM1557696Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft position actuator magnet bolts.
  4. Remove the camshaft position actuator magnet and O-ring seal.
scientia non olet · About LEMON Manuals