LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 3.5L - Repair Instructions - On Vehicle) >> Camshaft Position Actuator Magnet Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Camshaft Position Actuator Magnet & Bolts
    GM1557696Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the camshaft position actuator magnet O-ring seal and magnet.
  2. Install the camshaft position actuator magnet bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: Camshaft Position Actuator Magnet Electrical Connector
    GM1611455Courtesy of GENERAL MOTORS CORP.
  3. Connect the camshaft position actuator magnet electrical connector (2).
  4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals