LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (2 Of 3)) >> Water Inlet and Engine Coolant Thermostat Installation

Water Inlet and Engine Coolant Thermostat Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Thermostat Housing & Bolt/Stud
    GM1556817Courtesy of GENERAL MOTORS CORP.
  1. Install the thermostat.
  2. Install the water inlet.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the water inlet bolts and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals