LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (2 Of 3)) >> Valve Rocker Arm Cover Installation - Right Side

Valve Rocker Arm Cover Installation - Right Side

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Right Valve Rocker Arm Cover
    GM1557668Courtesy of GENERAL MOTORS CORP.
  1. Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
    2. NOTE: All gasket-mating surfaces need to be free of oil and foreign material. Clean surfaces. Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended cleaner.
  2. Install the valve rocker arm cover gasket into the valve rocker arm cover.
    3. Fig 2: Cylinder Head To Lower Intake Manifold Joint
    GM190588Courtesy of GENERAL MOTORS CORP.
  3. Apply sealer to the surfaces where the cylinder head and intake manifold meet (1). Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.
  4. Install the valve rocker arm cover.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the valve rocker arm cover bolts, if necessary, and tighten to 10 N.m (89 lb in).
    6. Fig 3: Identifying Fresh Air Tube
    GM1557664Courtesy of GENERAL MOTORS CORP.
  6. Install the fresh air tube into the valve rocker arm cover.
    7. Fig 4: Identifying Ignition Coil Assembly, Studs & Nuts
    GM1557662Courtesy of GENERAL MOTORS CORP.
  7. Install the ignition coil assembly studs, if necessary, and tighten to 25 N.m (18 lb ft).
  8. Install the ignition coil assembly.
  9. Install the ignition coil assembly bolts and nuts and tighten to 25 N.m (18 lb ft).
scientia non olet · About LEMON Manuals