LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (2 Of 3)) >> Oil Pump Drive Installation

Oil Pump Drive Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Oil Pump Drive
    GM1557691Courtesy of GENERAL MOTORS CORP.
  1. Apply prelube to the oil pump drive gear. Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended lubricant.
  2. Apply engine oil to the oil pump drive gear assembly for ease of assembly.
  3. Install the oil pump drive gear assembly.
  4. Install the oil pump drive gear clamp.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the oil pump drive gear clamp bolt and tighten to 36 N.m (27 lb ft).
scientia non olet · About LEMON Manuals