Special Tools

J 45059:  Angle Meter

For equivalent regional tools, refer to Special Tools

Fig 1: Identifying Crankshaft Rear Main Bearing Cap
Courtesy of GENERAL MOTORS CORP.
1. Apply sealer to both sides of the crankshaft rear main bearing cap (1). Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant. Press sealer into gap using a putty knife.
Fig 2: View Of Oil Pan Sealing Points
Courtesy of GENERAL MOTORS CORP.
2. Apply sealer to both sides of the front cover/block mating area (1). Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.
Fig 3: View Of Oil Pan & Bolts
Courtesy of GENERAL MOTORS CORP.
3. Install the oil pan gasket.
4. Install the oil pan.
CAUTION: Refer to Fastener Caution .
5. Install the oil pan bolts and tighten to 25 N.m (18 lb ft).
6. Apply sealer to the oil pan side bolt threads. Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.
7. Install the oil pan side bolts.
8. Tighten the oil pan side bolts a first pass to 50 N.m (37 lb ft).
9. Tighten the oil pan side bolts a second pass to 50 degrees using the J 45059:  meter.
Fig 4: View Of Oil Pan Drain Plug
Courtesy of GENERAL MOTORS CORP.
10. Install the oil pan drain plug and tighten to 25 N.m (18 lb ft).