LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (2 Of 3)) >> Engine Front Cover Installation

Engine Front Cover Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Front Cover & Gasket
    GM1713974Courtesy of GENERAL MOTORS CORP.
  1. Install the front cover and the front cover gasket.
    2. CAUTION: Refer to Fastener Caution .
    NOTE: Apply sealer to the shaded bolts (1) in the graphic. Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant. Failure to do so may result in engine coolant leakage from the bolt holes passing through the water jacket.
  2. Install the front cover bolts and tighten to 25 N.m (18 lb ft).
scientia non olet · About LEMON Manuals