LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (2 Of 3)) >> Crankshaft Front Oil Seal Installation >> Special Tools

Special Tools

WARNING: This page is about a different variant/trim than selected.

EN-48869  Front Crankshaft Oil Seal Installer. See Special Tools .

    Fig 1: Crankshaft Front Oil Seal And Installation Tool
    GM2047119Courtesy of GENERAL MOTORS CORP.
  1. Place the crankshaft front oil seal on the EN-48869  with lip facing inward, aligning crankshaft keyway to the groove in the installer. See Special Tools .
  2. Thread the forcing bolt with bearing, washer and nut as shown in illustration.
  3. Tighten the nut until seal bottoms, then remove the EN-48869  . See Special Tools .
scientia non olet · About LEMON Manuals