LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (3 Of 3)) >> Engine Coolant Crossover Pipe Installation

Engine Coolant Crossover Pipe Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Coolant Crossover Pipe Assembly & Bolts
    GM1645457Courtesy of GENERAL MOTORS CORP.
  1. Install the coolant crossover pipe gaskets and the coolant crossover pipe assembly onto the engine.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the engine lift bracket (1) and the front coolant crossover pipe bolts (4), and tighten to 50 N.m (37 lb ft).
  3. Install the side coolant crossover pipe bolt (2) and tighten to 10 N.m (89 lb in).
  4. Install the thermal bypass hose (3) and securely fasten the hose clamp.
    5. Fig 2: Identifying Idler Pulley Bolts & Pulleys
    GM1608911Courtesy of GENERAL MOTORS CORP.
  5. Install the idler pulleys and bolts.
    • Tighten the bolts (1) to 50 N.m (37 lb ft).
    • Tighten the bolt (2) to 30 N.m (22 lb ft).
scientia non olet · About LEMON Manuals