LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Wiring Harness Assemble

Wiring Harness Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Wiring Harness Assembly
    GM840867Courtesy of GENERAL MOTORS CORP.
  1. Inspect the wiring harness assembly (225) for:
    • Cut or pinched wires
    • Cut wire insulation
    • Bent or broken electrical connectors
    • Damaged terminal pins
    2. Fig 2: Wire Harness On Control Valve Body
    GM840869Courtesy of GENERAL MOTORS CORP.
  2. Position the wire harness assembly (225) onto the control valve body (300) and the pump cover (201).
  3. Mate each connector into its respective electrical component and engage the locking tabs.
  4. Secure the wiring harness conduit into the retaining clip (226) on the pump cover (201).
  5. Assemble the fluid temperature sensor (391) into the temperature sensor clip (390).
scientia non olet · About LEMON Manuals