Torque Converter Fluid Seal Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Cross Sectional View Of J 41103 Components

Courtesy of GENERAL MOTORS CORP.

Insert the three J 41103-1: puller legs under the Torque Converter Seal (525).
Insert the J 41103-3: support body over the drive sprocket support (522).
Insert the J 41103-2: puller bridge over the J 41103-3: support body. Connect theJ 41103-1: puller legs into the slots on the J 41103-2: puller bridge.

NOTE: The puller legs will damage the torque converter seal (525). Discard the torque converter seal (525) after removal.

Tighten the forcing screw on the J 41103-2: puller bridge until the J 41103-1: puller legs remove the torque converter seal (525).