Torque Converter Assemble: Assemble

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Turbine Shaft O-Ring Seal & Turbine Shaft

Courtesy of GENERAL MOTORS CORP.

Apply J-36850: lubricant or equivalent to a new turbine shaft O-ring seal (520).
Apply J-36850: lubricant or equivalent to the turbine shaft (518) splines.
Install the turbine shaft O-ring seal (520) onto the turbine shaft (518).

Fig 2: View Of Torque Converter Assembly

Courtesy of GENERAL MOTORS CORP.

WARNING: The torque converter weighs approximately 35 lbs. Personal injury may result if you lift the torque converter improperly.