LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Thermo Element Adjustment >> Adjustment

Thermo Element Adjustment: Adjustment

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Thermo Element, Plate And Plate Pins
    GM13015Courtesy of GENERAL MOTORS CORP.
  1. Remove the thermo element plate pins (120).
  2. Remove the thermo element (121) and the thermo element plate (122).
    3. Fig 2: Using J 34094-A To Set The Height Of The Thermo Element Plate Center Pin
    GM13016Courtesy of GENERAL MOTORS CORP.
  3. Use J 34094-A:  height gauge in order to set the height of the thermo element plate center pin (123).
  4. Install the thermo element plate (122).
  5. Use J 34094-A:  height gauge in order to set the height of the thermo element plate pin (120) that is farthest from the accumulators.
  6. Use J 34094-A:  height gauge in order to set the height of the second thermo element plate pin (120).
    7. Fig 3: View Of Thermo Element, Plate And Plate Pins
    GM13015Courtesy of GENERAL MOTORS CORP.
  7. Carefully install the thermo element (121) between the two thermo element plate pins (120).
  8. The V in the thermo element (121) must contact the thermo element plate (123).
scientia non olet · About LEMON Manuals