LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Manual Valve Link and Fluid Dam Assemble

Manual Valve Link and Fluid Dam Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Dam
    GM870971Courtesy of GENERAL MOTORS CORP.
  1. Install the oil dam (27) into the case.
  2. Assemble the manual valve link onto the manual shift detent lever/IMS detent lever.
    3. Fig 2: Connecting Manual Valve Link To Manual Valve
    GM48183Courtesy of GENERAL MOTORS CORP.
  3. Connect the manual valve link (402) to the manual valve (404).
  4. Install the manual valve link spring (403).
    5. Fig 3: Manual Shift Detent Assembly
    GM870968Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Install the manual shift detent assembly (804), and the manual shift detent bolt (805) and tighten to 12 N.m (106 lb in).
    6. Fig 4: View Of Input Speed Sensor
    GM48196Courtesy of GENERAL MOTORS CORP.
  6. Carefully install the input speed sensor (440) into the case cover (400).
  7. Install the input speed sensor clip (441) into the case cover (400).
scientia non olet · About LEMON Manuals