LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Forward Band Servo Components Disassemble

Forward Band Servo Components Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Servo Piston & Components
    GM678332Courtesy of GENERAL MOTORS CORP.
  1. Disassemble the servo piston return spring (22) from the forward band servo assembly.
  2. Remove the servo piston oil seal ring (18) from the servo piston (16).
  3. Using a small screwdriver, remove the servo pin retaining ring (15) from the servo piston apply pin (21).
  4. Disassemble the servo piston (16), the servo piston cushion inner spring (65), the servo piston cushion outer spring (19), the servo cushion spring retainer (20) and the servo piston apply pin (21).
scientia non olet · About LEMON Manuals