LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Driven Sprocket Support Components Disassemble >> Disassemble

Driven Sprocket Support Components Disassemble: Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of J 4670-01, Fourth Clutch Spring Assembly And Snap Ring
    GM10670Courtesy of GENERAL MOTORS CORP.
  1. Use J 4670-01:  spring compressor clutch spring compressor in order to compress the fourth clutch spring assembly (602). Remove the snap ring (601) from the driven sprocket support assembly.
    2. Fig 2: Spring Assembly & Fourth Clutch Piston Assembly
    GM10671Courtesy of GENERAL MOTORS CORP.
  2. Remove the spring assembly (602) and remove the fourth clutch piston assembly (603) from the driven sprocket support assembly (609).
    3. Fig 3: Locating Fourth Clutch Piston Outer Seal
    GM10672Courtesy of GENERAL MOTORS CORP.
  3. Remove the outer seal (604) from the fourth clutch piston (603).
    4. Fig 4: Inner Seal & Oil Seal Rings In Driven Sprocket Support
    GM788713Courtesy of GENERAL MOTORS CORP.
  4. Remove the inner seal (605) for the fourth clutch piston from the driven sprocket support assembly hub.
  5. Remove the oil seal rings (613) from the driven sprocket support.
scientia non olet · About LEMON Manuals