LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Driven Sprocket Support Assembly Removal

Driven Sprocket Support Assembly Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Driven Sprocket Support Assembly, Thrust Washer & Channel Plate Bolts
    GM870974Courtesy of GENERAL MOTORS CORP.
  1. With your fingers, insert two 13 mm channel plate bolts (434) into the driven sprocket support assembly (609).
  2. Grasp the bolts and lift the support assembly from the case.
  3. Remove the thrust washer (611) from the second clutch housing. The washer may be stuck to the support assembly.
scientia non olet · About LEMON Manuals