LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Drive Sprocket and Turbine Shaft Disassemble

Drive Sprocket and Turbine Shaft Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Seal Rings & Turbine Shaft
    GM49261Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not damage the grooves on the shaft, when removing the oil seal rings.
  1. Cut the oil seal rings (513, 519) from the turbine shaft (518).
  2. Remove the oil seal rings (513, 519).
    3. Fig 2: View Of Turbine Drive Sprocket & Retaining Ring
    GM49262Courtesy of GENERAL MOTORS CORP.
  3. Remove the drive sprocket retaining ring (515).
  4. Remove the drive sprocket (516) from the turbine shaft (518).
scientia non olet · About LEMON Manuals