LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Drive Sprocket and Turbine Shaft Assemble >> Assemble

Drive Sprocket and Turbine Shaft Assemble: Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Driven Sprockets Inspection Areas
    GM49263Courtesy of GENERAL MOTORS CORP.
  1. Inspect the driven sprocket (506) for the following:
    • Worn or chipped teeth
    • Uniform teeth size
    • Stripped or damaged splines
    • Bearing surface damage
  2. Inspect the fourth clutch shaft thrust washer (505) and the driven sprocket thrust washer (508) for wear or cracks.
    3. Fig 2: Drive Sprocket & Components Inspection Areas
    GM49265Courtesy of GENERAL MOTORS CORP.
  3. Inspect the drive sprocket (516) for the following:
    • Worn or chipped teeth
    • Uniform teeth size
    • Stripped or damaged splines
    • Bearing surface damage
  4. Inspect the turbine shaft (518) for the following:
    • A cracked sleeve
    • Damaged bushing journals
    • Stripped or damaged splines
  5. Inspect the drive sprocket thrust washers (514, 517) for wear or cracks.
    6. Fig 3: View Of Turbine Drive Sprocket & Retaining Ring
    GM49262Courtesy of GENERAL MOTORS CORP.
  6. Insert the turbine shaft (518) into the drive sprocket (516) and attach the drive sprocket retaining ring (515).
    7. Fig 4: Sliding Turbine Shaft Oil Seal Rings Into Position
    GM49266Courtesy of GENERAL MOTORS CORP.
  7. Install J 29569-1:  seal installer expander onto the turbine shaft (518). Coat the tool shaft with J 36850:  lubricant or equivalent.
  8. Slide the turbine shaft oil seal rings (513) into position.
    9. Fig 5: Sizing Turbine Shaft Oil Seal Rings With J 29569-2
    GM49267Courtesy of GENERAL MOTORS CORP.
  9. Use J 29569-2:  seal installer compressor in order to size the turbine shaft oil seal rings (513).
    10. Fig 6: Identifying J 29829-1A And Turbine Shaft
    GM49269Courtesy of GENERAL MOTORS CORP.
  10. Install J 29829-1A:  seal installer expander onto the turbine shaft (518). Coat the tool shaft with J 36850:  lubricant or equivalent.
  11. Slide the turbine shaft oil seal ring (519) into position.
    12. Fig 7: Identifying J 29829-2 & Turbine Shaft Oil Seal Ring
    GM49271Courtesy of GENERAL MOTORS CORP.
  12. Use J 29829-2:  seal installer compressor in order to size the turbine shaft oil seal ring (519).
scientia non olet · About LEMON Manuals