Drive Shaft Oil Seal Assemble - Right Side: Assemble

WARNING: This page is about a different variant/trim than selected.

Fig 1: Installing Axle Oil Seal With J 29130 & J 8092

Courtesy of GENERAL MOTORS CORP.

CAUTION: Install the seal onto the tool before installing into the case to prevent damage to the seal.

NOTE: Inspect the axle oil seal assembly (4). Be sure that the seal was not damaged during assembly. Check that the garter spring was not dislodged.

Use J-29130: seal installer and J-8092: driver handle in order to install the axle oil seal assembly (4) on the case extension assembly.