Differential Carrier Internal Gear Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Differential Carrier Internal Gear Snap Ring & Thrust Washer

Courtesy of GENERAL MOTORS CORP.

Remove the bearing (691) from the differential carrier internal gear.
Use J 28585: snap ring remover or a large screwdriver in order to remove the differential carrier internal gear snap ring (692).

Fig 2: Differential Carrier Internal Gear Assembly

Courtesy of GENERAL MOTORS CORP.

Lift the differential carrier internal gear assembly (693) out of the case by depressing the park pawl assembly in order to clear the case.