Control Valve Body Cover and Gasket Assemble: Assemble

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Control Valve Body Cover

Courtesy of GENERAL MOTORS CORP.

Inspect the control valve body cover (53) for the following conditions:
- Damaged or porous gasket sealing surfaces
- Damaged or porous casting surfaces
- Damaged or stripped bolt holes
Inspect the control valve body cover gaskets (54, 59) for damage. The gaskets are reusable if they are NOT damaged.

Fig 2: Control Valve Body Cover Gasket

Courtesy of GENERAL MOTORS CORP.

Assemble the control valve body cover inner gasket (59) to the control valve body cover (53). Use J-36850: lubricant or equivalent to retain the gasket in position.
Install the control valve body cover gasket (54) and control valve body cover (53) onto the case. Make sure the gaskets and electrical connector are positioned correctly.

Fig 3: Identifying Control Valve Body Cover Bolt And Control Valve Body Cover To Case Stud Bolt

Courtesy of GENERAL MOTORS CORP.

Install control valve body cover bolt (56) and one control valve body cover to case stud bolt (58) in the locations shown in illustration. These bolts will properly locate the control valve body cover and gasket to the case.

CAUTION: Refer to Fastener Caution .

Install the remaining bolts as indicated, and tighten to 25 N.m (18 lb ft).
- Nine control valve body cover bolts (56)
- Four control valve body cover TORX® head bolts (57)
- Four control valve body cover to case stud bolts (58)