LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Case Cover Components Assemble

Case Cover Components Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: 3-4 Accumulator Piston Components
    GM330198Courtesy of GENERAL MOTORS CORP.
  1. Install a new 3-4 accumulator piston cylinder O-ring seal (422) onto the 3-4 accumulator piston cylinder (421).
  2. Install the 3-4 accumulator piston outer spring (423) and inner spring (424) into the 3-4 accumulator piston cylinder (421).
  3. Install a new 3-4 accumulator piston seal (427) onto the 3-4 accumulator piston (428).
  4. Insert the 3-4 accumulator piston (428) into the 3-4 accumulator piston cylinder (421).
  5. Using a slight twisting motion, insert the 3-4 accumulator piston cylinder (421) into the case cover (401).
  6. Insert the 3-4 accumulator piston pin (426) through the front of the case cover (401) and into the 3-4 accumulator piston (428).
  7. Install the manual valve (404) into the case cover (401).
    8. Fig 2: View Of Actuator Feed Limit Valve, Spring & Retainer
    GM400527Courtesy of GENERAL MOTORS CORP.
  8. Install the actuator feed limit valve (414) into the case cover (401).
  9. Install the actuator feed limit valve spring (415) into the case cover (401).
  10. Install the actuator feed limit valve spring retainer (416) into the case cover (401).
scientia non olet · About LEMON Manuals