LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Case Cover Bearing Assemble >> Assemble

Case Cover Bearing Assemble: Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Drive Shaft Bearing With J 8092 And J 41991
    GM49306Courtesy of GENERAL MOTORS CORP.
  1. Assemble J 8092:  driver handle and J 41991:  bearing remover/installer for bearing installation.
  2. Place the case cover (400) on a clean, flat surface with the case mating surface up.
    3. NOTE: When installing the new bearing the part number should be visible (facing upward).
  3. Using the assembled tool, press the drive shaft bearing (431) into the case cover (400).
scientia non olet · About LEMON Manuals