LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 4T65-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> 2nd Clutch and Input Clutch Removal >> Removal

2nd Clutch and Input Clutch Removal: Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of J 33381-A
    GM10544Courtesy of GENERAL MOTORS CORP.
  1. Adjust the collar on tool J 33381-A:  remover/installer to the 4T65-E CLUTCH & DRUM setting. Make sure that the threaded rod is fully loosened.
    2. Fig 2: Identifying J 33381-A & Input Clutch Housing Assembly
    GM48267Courtesy of GENERAL MOTORS CORP.
  2. Install J 33381-A:  remover/installer into the second clutch housing assembly (617).
  3. Tighten the threaded rod of J 33381-A:  remover/installer until the rod is finger tight.
  4. Lift up J 33381-A:  remover/installer with the second clutch housing (617) and the input clutch housing (632) attached. The sprag clutch assemblies will also be attached.
  5. Place the complete assembly on the bench.
  6. Loosen the threaded rod of J 33381-A:  remover/installer.
  7. Remove J 33381-A:  remover/installer from the assembly.
    8. Fig 3: Identifying Second Clutch Housing & Input Clutch Components
    GM48591Courtesy of GENERAL MOTORS CORP.
  8. Lift the second clutch housing (617) off of the input clutch housing.
  9. Remove the input clutch housing thrust bearing (629) from the input housing.
  10. Remove the selective thrush washer (630) from the input clutch housing (632).
scientia non olet · About LEMON Manuals