Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0053, P0059, P0101, P0102, P0103, P0106, P0107, P0108, P0116, P0117, P0118, P0128, P0131, P0132, P0133, P0134, P0135, P0151, P0152, P0153, P0154, P0155, P0201-P0206, P0300, P0301-P0306, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P0606, P0641, P0651, P1133, P1516, P2101, P2120, P2122, P2123, P2125, P2127, P2128, P2135, P2138, P2176, P2A00 are not set.
The device control is not active.
The intrusive diagnostics are not active.
The engine overspeed protection is not active.
The power take-off (PTO) is not active.
The traction control is not active.
Reduced engine power is not active.
The engine is in Closed Loop status.
The system voltage is between 10-32 V for greater than 4 s.
The engine run time is greater than 50 s.
The engine coolant temperature (ECT) is warmer than -20°C (-4°F).
The engine speed is between 500-4,000 RPM.
The mass air flow is between 5-600 g/s.