Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

DTC P0716 detects a large change in the input speed signal in a very short period of time; an unrealistic change indicates an intermittent fault.
DTC P0717 detects a very low input speed when the vehicle speed is greater than a calibrated value indicates a continuous fault.
Inspect the ISS, wire harness, connector, and TCM for metallic debris, damage, or misalignment. Ensure the wiring harness is not stretched too tightly or other components are pressing on the automatic transmission inline 20-way connector body. Also inspect for proper clearance to any other components and wiring.