Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, using the remover J 44257 , disconnect the automatic transmission (AT) inline 20-way connector and install the jumper harness J 44152 on the transmission pass-thru connector. See Special Tools .
- Using the light-blue test probe J 35616-65B from the most current J 35616 GM terminal test kit, test for 820-1428 Ω between the ISS high signal circuit jumper harness pin S and the ISS low signal circuit jumper harness pin V.
- If greater than the specified range, test the affected circuits for an open/high resistance. If both circuits test normal, replace the ISS.
- If less than the specified range, test the affected circuits for a shorted together condition. If both circuits test normal, replace the ISS.