Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine running. Let the engine run for at least 1 minute.
- Ignition OFF for at least 30 seconds to allow for the complete shutdown of the TCM.
- Ignition ON, verify that DTC P0602 is not set.
- If DTC P0602 is set, reprogram the TCM. If the DTC resets, replace the TCM.
- Observe the DTC information with a scan tool. If DTC P0601, P0603, P0604, or P062F are set, replace the TCM.