Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0201-P0206, P0300, P0301-P0306, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P0506, P0507 are not set.
The engine is in Closed Loop status.
The catalyst monitor intrusive test is not active.
The post O2 sensor intrusive test is not active.
The device controls are not active.
The EVAP tank pull down test is not active.
The engine coolant temperature (ECT) is between -38 and +130°C (-36 and +266°F).
The intake air temperature (IAT) is between -20 and +150°C (-4 and +302°F).
The manifold absolute pressure (MAP) is between 15-256 kPa (2.2-37.1 PSI).
The engine speed is between 400-6,350 RPM.
The mass air flow (MAF) is between 1-512 g/s.
The barometric pressure (BARO) is more than 70 kPa (10.2 PSI).
The fuel level is greater than 10 percent.
These DTCs run continuously when the above conditions have been met.